Expired
Geeetech® TL-touch 3D-Touch Auto Bed Leveling Sensor – WHITE
$11.99
$15.59
$11.99
$15.59
Main Features:
● This is an auto leveling sensor for 3D printers based on open-source
● Simple, smart, high-precision, it could work with any kinds of bed materials, such as glasses, woods, metals and so on
● It can be operated in the following conditions: one I / O for control ( PWM or software PWM ), One I / O for Zmin( Z Probe ), GND and + 5V power
● This is an auto leveling sensor for 3D printers based on open-source
● Simple, smart, high-precision, it could work with any kinds of bed materials, such as glasses, woods, metals and so on
● It can be operated in the following conditions: one I / O for control ( PWM or software PWM ), One I / O for Zmin( Z Probe ), GND and + 5V power
Cautions:
● Additional power supply will be needed in case your board does not supply enough amperage
● Electronic devices can be damaged or even destroyed if connected to wrongpolarity ( wrong terminal connect to 5V ( + ) and GND ( – ) )
● Pulling / pushing hard on the push-pin can damage 3DTouch and make it less accurate
● Fix push-pin with locking paint after reassembling or adjusting core
● Do not remove or deform elastic material attached on the push-pin
Specification
General
Weight and Size
Package Contents
| Brand: Geeetech Materials: PCB Suitable for: Mainboard Control Type: DIY Accessories |
| Package size: 18.50 x 10.50 x 3.50 cm / 7.28 x 4.13 x 1.38 inches Package weight: 0.0220 kg Product size: 18.00 x 10.00 x 3.00 cm / 7.09 x 3.94 x 1.18 inches Product weight: 0.0190 kg |
| Package Contents: 1 x Sensor, 1 x 3 Pin Straight Pin, 1 x 2 Pin Straight Pin, 2 x Screw Nut Washer, 2 x Dupont Housing Shell 3 Pin, 2 x Dupont Housing Shell 2 Pin, 10 x Dupont Terminal, 1 x 10KΩ 1 / 8W Resistor |
